Same-day repairs for GE fridges, washers, dryers, dishwashers, ovens and stoves, backed by a 90-day warranty.
Real issues from real repairs, organized by appliance.
Fridge clicking every few minutes without cooling
Usually a start relay failing, which makes repeated attempts to start the compressor without success.
Ice buildup on the back interior wall
Often a defrost heater failing intermittently, letting frost accumulate instead of melting off on schedule.
Fridge door alarm going off even when closed
Usually a door switch sensing incorrectly, sometimes from a magnet that's shifted slightly out of position.
Freezer not cold enough despite fridge working fine
Often a damper stuck restricting airflow between the two compartments.
A recent repair
GE fridge, ice on the back interior wall
A GE fridge had a growing patch of ice building up on the back interior wall of the freezer. The defrost heater had an intermittent fault and wasn't reliably melting frost on schedule. Replaced the heater and monitored a full defrost cycle to confirm it cleared properly, with a 90-day warranty applied to the repair.
Washer vibrating heavily during spin
Often shipping bolts never removed after installation, or worn shock absorbers on an older machine.
Dryer timer knob not advancing
Usually a timer motor failure, which stalls the cycle at whatever stage it was on when it failed.
Washer filling with hot water on a cold setting
Often an inlet valve mixing internally, letting hot water through even when cold is selected.
Dryer door switch not registering as closed
Usually worn switch contacts, which stop the dryer from starting even with the door fully shut.
A recent repair
GE dryer, door switch not registering
A GE dryer wouldn't start even with the door firmly closed, showing no response at all. The door switch contacts had worn down and stopped making a reliable connection. Replaced the switch and confirmed the dryer started consistently over several tests, with a 90-day warranty applied to the repair.
Dishwasher smells musty between uses
Usually a drain hose trapping standing water, which sits and stagnates between cycles.
Heating element visible but dishes not drying
Often a heat control thermostat failure, which stops the element from actually reaching the temperature needed to dry dishes.
Cycle indicator lights not lighting up
Usually a control board fault, sometimes alongside other electrical symptoms.
Water leaking onto the floor after the cycle ends
Often a float switch not resetting properly, which can let the tub overfill on the next cycle.
A recent repair
GE dishwasher, leaking onto the floor
A GE dishwasher had started leaving a small puddle on the kitchen floor after cycles finished. The float switch was stuck and not resetting, letting the tub overfill slightly each time. Replaced the switch and ran a full cycle to confirm no further leaking, with a 90-day warranty applied to the repair.
Stovetop coil element not heating on one side
Usually an internal break in the element itself, which shows up as one section staying cold while the rest glows normally.
Oven door glass fogging up during use
Often a door seal allowing moisture in, which condenses on the inside of the glass during baking.
Self-clean cycle triggering a smoke smell
Usually accumulated grease burning off, which is normal but can signal the oven is overdue for a self-clean.
Control panel buttons sticking or double-registering
Often a worn membrane switch behind the panel, which becomes less reliable with age.
A recent repair
GE range, coil element not heating evenly
A GE range had one burner where half the coil stayed cold no matter the setting. There was an internal break partway along the element's coil. Replaced the element and confirmed even, consistent heat across the entire burner, with a 90-day warranty applied to the repair.
