Samsung Appliance Repair

Frost building up on the back wall

One of the most common complaints on Samsung fridges, almost always a defrost heater or thermostat that's stopped cycling properly, letting frost build up instead of melting off on schedule.

Compressor clicking but not starting

A failing start relay is the usual explanation, a small, inexpensive part that's far more likely to be the culprit than the compressor itself when it clicks repeatedly without catching.

Ice maker not filling with water

The water inlet valve freezing shut is a frequent cause during colder months, especially if the supply line runs anywhere near an exterior wall or unheated space.

Fridge warm, freezer working fine

A stuck air damper controls how much cold air the freezer shares with the fridge compartment, and when it sticks closed, the freezer keeps performing normally while the fridge side falls behind.

Washer stopping mid-cycle

Often a lid or door switch that isn't sensing the latch properly, which stops the machine from completing the wash or spin cycle it's on.

Drum shaking or walking during spin

Worn suspension springs or shock absorbers are the most common cause, especially on front-load models after several years of regular use.

Dryer running but not heating

Usually a burned-out heating element or a thermal fuse that's tripped, often because a restricted vent made the dryer run hotter than it should.

Loud banging or squealing noise

A worn drum bearing or a dry idler pulley are the usual suspects, and both get louder over time rather than appearing suddenly.

Water left standing at the end of a cycle

Usually a clogged drain pump or a kinked drain hose, which are the most common reasons water doesn't fully clear at the end of a wash.

Dishes coming out cloudy or gritty

A clogged spray arm or a filter that hasn't been cleaned in a while is behind most complaints about film or grit left on dishes.

Dishwasher won't start at all

Often a door latch that isn't fully engaging, since most models won't run a cycle unless the control board reads the door as securely closed.

Loud grinding sound during the wash

Almost always something small caught in the chopper blade near the pump, rather than a sign the motor itself has failed.

Oven not reaching temperature

A weak or failed bake element is the most common cause, and it's usually easy to spot once the element is inspected under load.

Burner won't light on a gas range

Often an igniter that's slightly out of position or a clogged orifice, both of which stop the spark from actually reaching the gas.

Electric element stuck on high heat

Usually a stuck infinite switch controlling that burner, rather than a fault with the heating element itself.

Control panel unresponsive or blank

Often a loose connection behind the panel or a control board fault, both of which we check before recommending a full board replacement.