Whirlpool Appliance Repair

Freezer frosting over quickly

Usually a clogged defrost drain or a defrost thermostat that's stopped cycling, letting frost build up faster than normal.

Fridge runs constantly, never cycles off

Condenser coils caked with dust are the most common cause, restricting airflow enough that the compressor never gets to rest.

Water pooling under the crisper drawers

Usually a frozen or blocked drain tube, sometimes made worse by a door gasket that's letting in warm, humid air.

Loud humming that gets worse over time

An evaporator fan motor wearing out is the usual explanation, and it tends to get louder gradually rather than failing all at once.

Washer won't spin, drum just fills and drains

Often a lid lock switch that isn't sensing the lid as closed, which stops the machine from ever reaching the spin stage.

Dryer takes multiple cycles to dry a load

Almost always a restricted vent rather than a fault with the dryer itself, and it's the one thing most people never check themselves.

Washer leaking from the bottom during the wash

Usually a failed door boot seal on front-load models, which lets water escape around the door during agitation.

Dryer drum not turning, motor hums

A snapped or slipped belt is the most common cause when the motor runs but the drum stays still.

Dishes coming out with a white film

Usually hard water combined with a detergent dispenser that isn't releasing fully partway through the cycle.

Dishwasher won't fill with water

Often an inlet valve stuck closed, which stops water from ever reaching the tub at the start of the cycle.

Door won't latch, cycle won't start

A worn latch assembly is the usual cause, since most models won't run unless the door reads as securely closed.

Buzzing noise during the drain phase

Usually a wash motor bearing wearing down, which gets louder over successive cycles rather than appearing suddenly.

Oven takes forever to preheat

A weakening igniter or bake element is the usual cause, and it tends to get slower gradually rather than failing outright.

Stovetop knob spins freely, won't click into position

Usually a worn detent spring inside the knob assembly, not a fault with the burner or valve itself.

Self-clean cycle won't finish

Often a door lock switch not engaging in the correct sequence, which the control board reads as unsafe to continue.

Oven light won't turn on

Usually a socket or bulb failure, though occasionally a wiring fault behind the panel is the real cause.